This article will discuss wholesale PTFE welder for sale the correct

procedures for cleaning both the inside and outside of your Fastback

15xs binding machine. One important note... You should NEVER use

goof off, goo gone or other similar cleaning solutions on your

Fastback. These harsh cleaners can actually damage the Teflon coating

on your platen resulting in a very expensive service call.

Usually no maintenance is necessary for

your binder, but if a strip jams, or adhesive gets on the Fastback, you

might have to do a little cleaning. This article will discuss the

correct procedures for cleaning both the inside and outside of your

Fastback 15xs binding machine. You shouldn't need to clean your machine

very often but when you do it is important that you clean it properly

to prevent damage from occurring to your machine. One important note...

You should NEVER use goof off, goo gone or other similar cleaning

solutions on your Fastback. These harsh cleaners can actually damage

the Teflon coating on your platen resulting in a very expensive service

call.

Cleaning the Outside of Your Fastback 15xs Binding Machine

If the outside of your Fastback starts to get dusty, clean the cover

with a damp cloth and mild detergent. If there's adhesive on the inner

book clamps open the cover, then wipe off the glue with a cotton rag

dampened with the Icky Sticky Stuff Remover cleaning solution. The glue

should come right off.

Cleaning the Inside of Your Fastback Binder

If a strip gets jammed or stuck to the platen, or if adhesive has

melted onto the platen, you'll need to clean it. If you have time

(about an hour), turn off the machine and let it cool completely. When

the platen is completely cool, the adhesive should peel off with no

trouble. If you can't wait for the binder to cool, follow these steps:

1. First put on the heat-protective glove. Since the platen can be very

hot, always wear this glove when working with the platen.

2. Now open the cover to its full upright position. The platen is the

teflon-coated plate that runs across the center of the unit.

3. To access the top of the platen, flip up the book rest. If the

platen is hot, make sure you're wearing the heat protective glove, then

wipe off any glue with a clean dry cotton cloth. Wipe the surface

lengthwise until it's clean. Do not use "Icky Stick Stuff Remover" or a

"Citrus Solution" on the platen when the platen is hot. If the unit has

cooled, wipe off any glue with a cotton cloth dampened in the Icky

Sticky Stuff Remover cleaning solution. You can also peel the adhesive

off the upper side of the platen with your fingers (or a wooden

instrument, like an ice cream stick).

Posted by: welbingmachine--3.2 kw Canvas Welding Machine Suppliers at 02:02 AM | No Comments | Add Comment
Post contains 479 words, total size 3 kb.